pipe with multiple orifices
Posted: Wed Jan 23, 2019 4:01 pm
Hello to all,
I have a question..
I have an pipe long 100mm with internal diameter 16mm and multiple orifices (number 8) of 2mm disposed radially on the top. I use inlet fluid air to 100°C with an pressure of 100mbar.
With this software I use the ORIFICE METHOD and ADDING the features above I obtain this result :
flow=16.66 l/min
velocity=88.40 m/sec
I calculate for each orifice and after multiply for 8 (orifices)?
is correct this result? I must use other method?
An reply is appreciated..
Thanks in advance
Marco
I have a question..
I have an pipe long 100mm with internal diameter 16mm and multiple orifices (number 8) of 2mm disposed radially on the top. I use inlet fluid air to 100°C with an pressure of 100mbar.
With this software I use the ORIFICE METHOD and ADDING the features above I obtain this result :
flow=16.66 l/min
velocity=88.40 m/sec
I calculate for each orifice and after multiply for 8 (orifices)?
is correct this result? I must use other method?
An reply is appreciated..
Thanks in advance
Marco