Gravity feed pressure

Forum about flow calculators available on pipeflowcalculations.com and how to find solution for your fluid flow problem.
Post Reply
dion
Posts: 1
Joined: Thu Jul 30, 2020 1:28 pm

Gravity feed pressure

Post by dion »

Hi,

I want to replace my 15kW motor powered irrigtion system with a gravity one. I have a high hill on my farm and wish to confirm that the dam I wish to place on it is high enough. Also, the width of the the pipe I need to use. Are there any tutorials I can examine to perform the necessary calculations?

Regards,
Dion
admin
Site Admin
Posts: 375
Joined: Mon Feb 08, 2010 7:47 pm

Re: Gravity feed pressure

Post by admin »

Hi,
To get information about the pipe diameter needed, you can use following calculator:
https://www.pipeflowcalculations.com/pr ... ator.xhtml

Select from the top button bar to calculate D (press D button), for the pressure p1 - select m H2O as a unit - that's you actual hight of the hill, enter pressure drop - the same value as p1 - it means that all available energy will be used, enter flow Q as you wish, and enter a value for pipe length.
Hit calculate and you should get pipe diameter D calculated.

Hope this helps.
Pipe flow calculations - since 2000
Post Reply