Pressure drop Calculation.

Forum about flow calculators available on and how to find solution for your fluid flow problem.
Post Reply
Joined:Tue Dec 04, 2018 3:42 pm
Pressure drop Calculation.

Post by santosh » Wed Dec 05, 2018 7:18 am

Hello, I am trying to calculate the pressure drop for LPG.
The case is as follows, From Point 1 which is at the ground floor, I will be taking a vertical pipe of 40 mm diameter up to point 2 at 275 m height. The mass per consumption would be 19.5 Kg/hr. The pressure at point 1 after leaving the Pressure Regulation System (PRS) will be 200 milli bar. I have tried calculating using the software but found some different results.

I have attached the screenshot for your reference. Please guide me where I provided wrong input to the software.
1.PNG (107.6KiB)Viewed 13075 times

Site Admin
Joined:Mon Feb 08, 2010 7:47 pm

Re: Pressure drop Calculation.

Post by admin » Wed Dec 05, 2018 9:45 pm

First, you have to enter absolute, not gauge pressure.
Check the pipe diameter that you are entering, as well as critical pressure and temperature for LPG.
Also, select to enter w (on the right side of the calculator) and then enter mass flow rate.
Hope this helps.
Pipe flow calculations - since 2000

Joined:Thu Dec 06, 2018 6:26 pm

Pressure drop Calculation

Post by KennethBib » Mon Dec 10, 2018 8:53 am

about 1/40th of the usable pressure, if you are getting 40 usable shots

In other words, not enough to show on the gauge, if you see gauge movement after one shot, you have a problem
Лучший сайт знакомств в любом городе и даже стране! Перейти

Post Reply