Orifice plate with pipe taps

Forum about flow calculators available on pipeflowcalculations.com and how to find solution for your fluid flow problem.
Post Reply
Joined:Fri Nov 08, 2013 4:33 pm
Orifice plate with pipe taps

Post by jcgod » Fri Nov 08, 2013 4:55 pm

I have to recalculate an orifice plate for an existing installation with pipe taps but the fluid flow calculator only allows for d-d/2, corner or 1" taps. The actual plate has a bore of 46,62mm, the pipe is 82,8mm id, the pressure drop is 250mbar, the pressure is 5bar, the temp 20º C and the fluid is water. The plate was calculated for 34m3/h and I need to recalculate for 40m3/h. Using the fluid flow calculator I get 27,9m3/h for the actual plate and a pressure drop of 500mbar for 39,4m3/h for corner taps. How can I correct thee values for pipe taps?

Site Admin
Joined:Mon Feb 08, 2010 7:47 pm

Re: Orifice plate with pipe taps

Post by admin » Sat Nov 09, 2013 9:13 pm

What do you mean by pipe taps?
You have corner taps as selection also - if plate is between flanges and taps are on flanges itself.
Pipe flow calculations - since 2000

Post Reply