Bevel on orifice plate

Forum about flow calculators available on and how to find solution for your fluid flow problem.
Joined:Sat May 05, 2012 10:03 am
Bevel on orifice plate

Post by baloo2k » Sat May 05, 2012 10:15 am

A standard gas flow measurement orifice is equipped with a standard bevel on the downstream side. This is considered in most of the commercial orifice calculation programs.

Does anybody have an idea, how to calculate the dp in case the orifice plate is installed in the wrong direction (i.e. bevel towards the upstream side)?

Many thanks in advance....

Post Reply