Hello to all,
I have a question..
I have an pipe long 100mm with internal diameter 16mm and multiple orifices (number 8) of 2mm disposed radially on the top. I use inlet fluid air to 100°C with an pressure of 100mbar.
With this software I use the ORIFICE METHOD and ADDING the features above I obtain this result :
I calculate for each orifice and after multiply for 8 (orifices)?
is correct this result? I must use other method?
An reply is appreciated..
Thanks in advance
Forum about flow calculators available on pipeflowcalculations.com and how to find solution for your fluid flow problem.
1 post • Page 1 of 1