Suction inlet flow through many orifices

Forum about flow calculators available on pipeflowcalculations.com and how to find solution for your fluid flow problem.
Post Reply
pieterdl
Posts: 2
Joined: Wed Nov 17, 2010 3:37 pm

Suction inlet flow through many orifices

Post by pieterdl »

I am designing a floating suction inlet pipe. The required flow rate is 1050 cubic meters per hour. The total length of the suction pipe is 20m. The suction piece will be a pipe section in which many small holes, say 8mm diameter is drilled. Will it be correct to argue that the total cross sectional area of all the holes should be equal to the area of the suction hose itself in order to acommodate the required flow?
Thanx
admin
Site Admin
Posts: 375
Joined: Mon Feb 08, 2010 7:47 pm

Re: Suction inlet flow through many orifices

Post by admin »

It depends if you want to achieve maximum possible flow rate or not. For maximum possible flow rate area should be at least equal. If not, than it does not matter.
Pipe flow calculations - since 2000
Post Reply