Air flow with Sharpe Edge orifice experi

Forum about flow calculators available on pipeflowcalculations.com and how to find solution for your fluid flow problem.
Post Reply
TSYEO
Posts: 1
Joined: Fri Oct 12, 2012 3:23 am

Air flow with Sharpe Edge orifice experi

Post by TSYEO » Fri Oct 12, 2012 4:08 am

Hi,

I am task to do an small experiment by using a air pump set up to determine the Cd of orifice plate. A 14.5mm (D) PVC pipe with orifice diameter 8.5mm is installed and connected to an air pump. I put one pressure tab at upstream and one at downstream with distance D and D/2 from the orifice. An differential pressure is then measured by meter say 125 Pa. The pump that I am using without specification given, thus I do not know the pump speed and flow rate. I used manometer to measure the volume flow rate at the end of the pipe which given me 0.113 m³/s. I plug the measured measurement and known elements into the given equation, I couldn’t get the Cd around 0.65,

1) what is gone wrong on the calculate Cd?

2) What is appropriate the upstream pipe and downstream pipe length be for the set up?

3) Is the equation applicable to small pipe flow?

Equation:-
Q = Cd x Ao x Sq root ( 2x Diff Pressure /(air Density x (1- Bata^4))

Where:
Q = Volume flow rate through the pipe
Cd = Orifice Coefficient
Ao = Area of Orifice
P= Density of air Bata = Diameter of orifice /Diameter of pipe

I assumed the air flow is laminar as the flow speed is at about 7.8 m/s.

admin
Site Admin
Posts: 371
Joined: Mon Feb 08, 2010 7:47 pm

Re: Air flow with Sharpe Edge orifice experi

Post by admin » Fri Oct 12, 2012 7:04 am

Have you tried with orifice plate calculator?
There is also button that will launch theory page which gives you equation for flow coefficient.
Pipe flow calculations - since 2000

Post Reply