how to design the DP of flow transmitter

Forum about flow calculators available on pipeflowcalculations.com and how to find solution for your fluid flow problem.
Post Reply
ajay
Posts: 4
Joined: Tue Sep 07, 2010 12:04 pm

how to design the DP of flow transmitter

Post by ajay » Thu Sep 09, 2010 9:46 am

dear all,

please tell me how to design the DP of DPT(flow transmitter)

for example :if I have to measure the level of water tank which is open to atmosphere,how can we determine the DP of Fow Transmitter

I think from following parameters we can calculate the DP

Density of water,

depth of water tank,

total head acting on bottom side of water tank,

if we can ,then please tell me the Details formula for calculating the same

please do the needful


regards,

Ajay Bhalerao
Wardha

admin
Site Admin
Posts: 365
Joined: Mon Feb 08, 2010 7:47 pm

Re: how to design the DP of flow transmitter

Post by admin » Thu Sep 09, 2010 8:49 pm

I am not sure if I understand you correctly, but the hydrostatic pressure of water or any other fluid is p=rho*g*h [Pa]
Pipe flow calculations - free fluid flow calculators
http://www.pipeflowcalculations.com/
Find pipe flow calculations on the Facebook
http://www.facebook.com/PipeFlowCalcs

Post Reply