Pipe diameter

Forum about flow calculators available on pipeflowcalculations.com and how to find solution for your fluid flow problem.
Post Reply
jbdefense
Posts: 1
Joined: Fri Apr 13, 2012 7:12 am

Pipe diameter

Post by jbdefense » Fri Apr 13, 2012 7:32 am

I am designing a washing system that utilizes 36 nozzles. Each nozzle will have a flow rate of 3 gal/min at 2500 psi. In addition to this each of the nozzles are fed by 36 individual braid reinforced silicone tubes with 3/8" diameter. The tubes will be fed by a single pipe. I am unsure of how to determine the diameter of the pipe that will feed the tubes. Additional information that may help is that the water will have a density of 977 kg.m^3, and the viscosity is 2.34*10^-5 lb*s*ft.

Any information on how to obtain the pipe diameter will be greatly appreciated.

baloo2k
Posts: 3
Joined: Sat May 05, 2012 10:03 am

Re: Pipe diameter

Post by baloo2k » Tue May 08, 2012 9:54 am

Normal flow velocities through a water pipe are 2-2.5 m/s. This can be used to size the header pipe. Pressure drop in this pipe should not have a significant influence, as a large pressure drop seems to be over the nozzles. Thus maldistribution of the flow is excluded.

If the nozzle tie-ins into the header are arranged in a long line, you may evaluate to stepwise reduce the header diameter in flow direction to maintain a certain flow velocity also towards the end of the header pipe (in order to avoid fouling/scaling/settling in the pipe).

Post Reply